Jump to content

Switching from Apex to GHL?


Tmcca
 Share

Recommended Posts

I am trying to figure out what I need in order to switch.

I have 3 optical sensors for my Apex through FMM. Sump Low/Sump High and Ato Low

I have a floor leak sensor as well.

I also have a fan hooked up to 24VDC port. Does GHL support that?

I think need a leak sensor interface; Y split cable I am guessing for Low/High Sump; Probably need to buy expansion card for my level sensors that is a guess though.

 

Thanks

 

Link to comment
Share on other sites

You would need a leakage interface and a leak sensor for the leak detection.  For your sump you would only need a y splitter for floats and 2 floats. And for ato a single sensor. With a Profilux4 you don’t have to buy any expansion card it has the float plugs on it for up to 4 floats. 
Ghl has 12v output not 24 that I know of. Not sure if could make your own way for it to run using 0-10 dimming channel.  If not then ghl has the propellerbreeze that can be controlled thru the 0-10v.  

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...